Dimensions check for the Ledgers in Sage X3

Ever ran into a situation where you are asked to enter dimensions (get the below screen shot) for a particular ledger account even if no Dimensions are set against the account. And you are not allowed to do the transaction unless you provide the dimensions to that Account

To create/perform transactions in Sage X3 without any dimensions just follow the below simple steps:

1. Go to Setup -> Organizational Structure -> Ledgers

      2.  Uncheck the option ‘At least one dimension’ for type of ledgers for which you wish to not use any dimension on the transactions.

Based on this option ‘At least one dimension’ selection for the different ledgers setup, users in Sage X3 are asked for the dimensions when creating or performing any transactions.